


| Parameter | Nilai |
|---|---|
| Barang | Specifications |
| Kabel | 6–core cabtyre cable, 5 m16.404 ftlong |
| Catatan | Where measurement conditions have not been specified precisely, the conditions used were ambient temperature +23 ℃+73 ℉.■Transponder specificationsOperating frequency: 125 kHzMax. transmitter output: 3.33 μW |
| Berat | Switch body (standard): 180 g approx., Actuator : 20 g approx. |
| Butiran | Visible type(Low code / Standard) |
| Produk | Non-Contact Safety Door Switch |
| Bahan | Switch body: PBT, PC, SUS (stainless steel), EPDMActuator: PBT, PC |
| Nombor Bahagian | SG-P1020-M-P |
| Berat kasar | 270 g approx. |
| Nama produk | Non-Contact Safety Door Switch SG-P |
| Voltan kuasa | 24V DC+10-20% Ripple P-P 10 % or less |
| Masa tindak balas | • For single unit: ON→OFF 100 ms or less, OFF→ON 100 ms or less• For multiple units: Time for single unit + 5 ms x (number of connected units - 1) |
| Nombor Produk | SG-P1020-M-P |
| Tahap pencemaran | 3 |
| Penggunaan semasa | 30 mA or less |
| Semak input dan output | Dedicated communication line between the switch body (standard) and the switch body (sub) (Note)* It is not for external input and output. (voltage range 0 V to 5 V DC)(Note) : When using the device as a single unit, connect the check input with the check output. |
| Panjang kabel yang disambungkan | • When using only one unit: Maximum cable length of 20 m 65.617 ft between switch body and power supply unit• When connecting multiple units in series: Maximum total cable length of 100 m328.084 ft, maximum cable length of 20 m65.617 ftbetween two adjacent units |
| Piawaian yang berkenaan: Jepun | JIS B 9705-1, JIS C 0508-1 to 3 (SIL3), JIS B 9961, JIS C 8201-5-2, JIS B 9710 |
| Piawaian yang berkenaan: Eropah | EN ISO 13849-1 : 2015 (Category 4, PLe), EN ISO 14119, EN 60947-5-3, EN 300 330, EN IEC 63000, EN 301 489-1 |
| Output kawalan (OSSD 1, OSSD 2) | PNP open-collector transistor 2 outputs• Maximum source current: 100 mA• Applied voltage: Same as the power supply voltage (PNP output: between control output and +V)• Residual voltage: 2 V or less (source current and sink current: 100 mA) (excluding voltage drop due to cable)• Leakage current: 0.2 mA or less (including power OFF state)• Maximum load capacity: 0.47 μF• Load wiring resistance: 3 Ω or less |
| Jarak operasi: Depan / Sisi | Sao (OFF→ON): 5 mm0.197 in, Sar (ON → OFF): 15 mm0.591 in |
| Piawaian yang berkenaan: Amerika Utara | CAN/CSA C22.2 No.14, UL508 |
| Bilangan unit yang disambungkan secara siri | 30 units or less (standard 1 unit, sub 29 units) |
| Output kawalan (OSSD): Litar perlindungan | Incorporated |
| Peraturan dan pensijilan yang berkenaan | CE Marking (Machinery Directive, RE Directive, RoHS Directive), UKCA Marking (Supply of Machinery (Safety) Regulations, RE Regulations, RoHS Regulations), TÜV SÜD certification, TÜV SÜD certification (U.S.A., Canada), the U.S.'s radio regulations (FCC) (Note), Canada's radio regulations (ICES-003, RSS-310) (Note), Singapore's radio regulations (IMDA certification) (Note), Thailand's radio regulations (NBTC certification) (Note), Philippines' radio regulations (NTC certification) (Note), Korea's radio regulations (KC certification) (Note), India's radio regulations (WPC certification) (Note)(Note) : This product uses a weak radio signal for its detection operation. Please confirm compliance with applicable laws in the country of use. |
| Rintangan alam sekitar: Kelembapan ambien | 30 to 85 % RH, storage: 30 to 95 % RH |
| Rintangan alam sekitar: Rintangan kejutan | 300 m/s2(approx. 30 G), 3 times each in X, Y, and Z direction |
| Piawaian yang berkenaan: Piawaian antarabangsa | ISO 13849-1 : 2015 (Category 4, PLe), IEC 61508-1 to 3 (SIL3), IEC 62061 (SIL3), IEC 60947-5-3, ISO 14119 |
| Rintangan alam sekitar: Suhu ambien | -10 to +55 ℃+14 to +131 ℉(No dew condensation or icing allowed), Storage: -25 to +65 ℃-13 to +149 ℉ |
| Rintangan alam sekitar: Tahap perlindungan | IP65(IEC) |
| Rintangan alam sekitar: Rintangan getaran | 10 to 55Hz, 1 mm double amplitude, 2 hours each in X, Y, and Z directions |
| Rintangan alam sekitar: Rintangan penebat | 20 MΩ or more, with 500 V DC megger between all supply terminals connected together and enclosure |
| Output kawalan (OSSD 1, OSSD 2): Mod operasi | • When the actuator is detected (safe state): ON• When the actuator is not detected (unsafe state or lockout state): OFF• When the switch body (sub) does not detect actuator (series connection): OFF |
| Rintangan alam sekitar: Ketahanan voltan | 1,000 V AC for one minute between all supply terminals connected together and enclosure |
Spesifikasi teknikal dan data prestasi
Panduan pemasangan dan operasi