

| Parameter | Nilai |
|---|---|
| • WARNING: Serve only products in perfect condition. Products should be checked regularly for damage. Remove defective products immediately. Replace damaged products. It is not possible to repair them. | |
| Dilindungi | No |
| Jenis kabel | TPE braided yarn |
| Kitaran Palam | > 100 |
| Jenis Sensor | Universal |
| Panjang kabel | 0.5 m |
| Kodifikasi | to |
| Bahagian Garisan | 0.34 mm² |
| Jenis Produk | Circular connectors (equipment side) |
| Nota Keselamatan | WARNING: Connectors should not be plugged in or unplugged under load. Failure to comply and improper use can result in property damage and personal injury. |
| Kategori Lonjakan | Ii |
| Talian Isyarat AWG | 22 |
| Jenis sambungan | Single braided threads |
| Bahan gasket | FKM |
| Rintangan Garisan | ≤ 57.6 mΩ/m |
| Bilangan tiang | 5 |
| Bahan sentuh | CuZn |
| Indeks Perlindungan | IP67 (In plugged in state) |
| Peraturan/Peruntukan | IEC 61076-2-101 |
| Jenis pemasangan | Rear wall mount |
| Tork pengetatan | 3 Nm ... 4 Nm (on the mounting side) |
| Rintangan sentuhan | ≤ 3 mΩ |
| Jenis thread pengepala | M12 |
| Arus Nominal IN | 4 A |
| Voltan nominal UN | 60 V |
| Kabel Voltan Ujian | 2000 V AC |
| Bahan Konduktif | Tinned Cu Conductor |
| Tahap pencemaran | 3 |
| Pembinaan pengepala | Male connector |
| Jenis/Kategori Isyarat | Universal |
| Pemandu Tunggal, Warna | black, brown, blue, white, gray |
| Rintangan penebat | ≥ 100 MΩ |
| Kabel Voltan Nominal | 300 V |
| Bilangan Saluran Kabel | 1 |
| Hubungi Bahan Sokongan | AP 6.6 |
| Denominasi piawai | M12 connector |
| Arahan pemasangan | with flat nut |
| Bahan: Permukaan Sentuh | Au |
| Rintangan Konduktor Maks. | 57.6 mΩ/m |
| Bahan sambungan skru | Zinc die-cast iron, nickel-plated |
| Penebat Ketebalan Dinding | 0.21 mm (Conductor Insulation) |
| Rintangan Penebat Talian | ≥ 20 MΩ*km |
| Suhu Ambien (Perkhidmatan) | -40 °C ... 85°C (cable, fixed arrangement) |
| Voltan Sementara Pengukuran Dimensi | 1.5 kV |
| Bahan: Penebat Konduktor | TPE |
| Kabel Isyarat Pembinaan Konduktor | 7x 0.25 mm |
| Diameter konduktor termasuk penebat | 1.2 mm ±0.07 mm |
| Pemerhatian mengenai operasi | The electrical and mechanical values listed require a pair of plug-in connectors that are properly assembled and locked. If the plug-in connector is unlocked and there is a danger of contamination, the plug-in connector must be closed with a cap > IP54. In addition, influences by conductors, lines, or assembly of printed circuit boards must be considered. |
| Kelas mudah terbakar mengikut UL 94 | V0 |
Spesifikasi teknikal dan data prestasi
Panduan pemasangan dan operasi