


| Parameter | Nilai |
|---|---|
| Barang | Specifications |
| Berat | Net weight: 155 g approx., Gross weight: 220 g approx. |
| Butiran | Aluminum body type |
| Paparan | 4 digits + 4 digits 2-color LCD display (Display refresh rate: 250 ms, 500 ms, 1,000 ms, selectable by key operation) |
| Produk | Integrated Display Type Digital Flow Sensor |
| Bahan | Enclosure: ABS, Body: Polyamide (Aluminum body type: Aluminum), Switch: EPDM, Display: Acrylic, Mounting screw part (Resin body type): Brass Current plate / Port filter: Stainless steel (used for the gas contact area), Sensor chip: Silicon, Gasket: Fluorine rubber |
| Lineariti | Within ±3 % F.S. (Ambient temperature +25 ℃ +77 ℉, flow rate range 3 to 100 % F.S., atmospheric criteria on secondary side) |
| Saiz port | G1/2 female thread |
| Perlindungan | IP40 (IEC) |
| Aksesori | CN-F15-C1 (Connector attached cable 1 m 3.281 ft): 1 pc. |
| Nombor Bahagian | FM-255-AG2-P |
| Panjang kabel | Total length up to 10 m 32.808 ft is possible with 0.3 mm2, or more, cable. |
| Nama produk | Integrated Display Type Digital Flow Sensor FM-200 |
| Kebolehulangan | Within ±1 % F.S. |
| Input luaran | ON voltage: +5 V to +VOFF voltage: 0 to +0.6 V, or openInput time: 80 ms or more |
| Nombor Produk | FM-255-AG2-P |
| Voltan bekalan | 12 to 24 V DC ± 10 % Ripple P-P10 % or less |
| Kelembapan ambien | 35 to 90 % RH, Storage: 35 to 90 % RH |
| Cecair yang berkenaan | Clean air, compressed air, nitrogen gas(Note):The clean air complies with JIS B 8392-1.1.1 to 5.6.2, and the compressed air complies with JIS B 8392-1.1.1 to 1.6.2. |
| Rintangan kejutan | 100 m/s2acceleration (10 G approx.) in X, Y and Z directions three times each |
| Kaedah penyambungan | Connector |
| Output perbandingan | PNP open-collector transistor・Maximum source current: 50 m A or less・Applied voltage: 26.4 V DC or less(between comparative output and +V)・Residual voltage: 2.4 V or less (at 50 mA source current) |
| Pembumian kandang | Floating(Note):As a varistor (clamping voltage: approx. 40 V) is connected to the aluminum body type, do not apply voltage higher than the rated voltage of the sensor. |
| Suhu ambien | 0 to +50 ℃ +32 to +122 ℉ (No dew condensation allowed), Storage: -10 to +60 ℃ +14 to +140 ℉ |
| Penggunaan semasa | Normal mode: 60 mA or less, ECO mode: 40 mA or less |
| Kadar aliran skala penuh | 500 ℓ/min.(Note):Converted to volumetric flow at +20 ℃ +68 ℉ and 1 atmospheric pressure (101 kPa). |
| Julat tekanan yang dinilai | -0.09 to +0.7 MPa |
| Rintangan getaran | 10 to 150 Hz frequency, 0.75 mm0.030 indouble amplitude or 49 m/s2max. acceleration, in X, Y and Z directions for two hours each |
| Output voltan analog | Output voltage: 1 to 5 V, Output impedance: 1 kΩ approx.[Refer to "Analog voltage output" for more details.] |
| Rintangan penebat | 10 MΩ, or more, with 500 V DC megger between all supply terminals connected together and enclosure (Excluding the aluminum body type) |
| Julat jaminan ketepatan | Bi-direction : -100 to -3 % F.S., +3 to +100 % F.S.One-side direction : +3 to +100 % F.S.(Note):Take care that if fluid flows in the vicinity of zero-point which is out of the accuracy assurance range, the instant flow rate value may forcibly display "zero", or the integrated flow display value may not be counted up, or the integrated pulse output may not be outputted. |
| Ciri-ciri tekanan | Within ±5 % F.S. (-0.09 to +0.7 MPa, +25 ℃ +77 ℉, atmospheric criteria on secondary side) |
| Ketahanan voltan | 1,000 V AC for one min. between all supply terminals connected together and enclosure (Excluding the aluminum body type) |
| Ketahanan tekanan | 1 MPa |
| Nilai bersepadu yang ditentukan | 5 ℓ |
| Ciri-ciri suhu | Within ±0.2 % F.S./℃ (+25 ℃ +77 ℉ criteria, +15 to +35 ℃ +59 to +95 ℉ ambient temperature range) |
| Output perbandingan: Histeresis | Window comparator mode: 1 to 8 % F.S. approx. (variable) (Factory settings: approx. 1 % F.S.), Hysteresis mode: Variable (minimum 1 digit) |
| Pematuhan arahan penandaan CE | EMC Directive, RoHS Directive |
| Output perbandingan: Mod output | Output OFF mode, window comparator mode, hysteresis mode, integrated output mode, integrated pulse output mode |
| Kadar aliran segera: Julat paparan | -550 to +550 ℓ/min.(Note):The display flow rate range is the case when setting to bi-direction at the flow direction setting. When the flow direction is set to one-side forward direction or one-side reverse direction, the negative side of the display flow rate range shows 10 % of the full-scale (F.S.). |
| Output perbandingan: Masa tindak balas | 50 ms, 80 ms, 120 ms, 200 ms, 400 ms, 800 ms, 1,500 ms, selectable by key operation |
| Kadar aliran bersepadu: Julat paparan | ±9999999 ℓ(Note):The display flow rate range is the case when setting to bi-direction at the flow direction setting. When the flow direction is set to one-side forward direction or one-side reverse direction, the negative side of the display flow rate range shows 10 % of the full-scale (F.S.). |
| Output perbandingan: Perlindungan litar pintas | Incorporated |
| Kadar aliran segera: Tetapan dan resolusi paparan | 1 ℓ/min. |
| Kadar aliran bersepadu: Tetapan dan resolusi paparan | 1 ℓ |
Spesifikasi teknikal dan data prestasi
Panduan pemasangan dan operasi